Non-woven wallpaper is also known as non-woven paper wallpaper is one of the senior wallpaper/wallpaper, because made from natural plant fiber non-woven technology pull is stronger, more environmental protection, not moldy yellow, good permeability is the first base material of high quality wallpaper.
Non-woven wallpaper method:
1. Wall treatment
Metope requests smooth, clean, dry, colour is even common, should have no empty space, convex and concave unequal defect, before construction metope should do brush base film (or varnish) processing.
2. Cutting wallpaper
In accordance with the serial number of the wallpaper wallpaper set, measuring the height of the wall, on the basis of the height of the wall above and reserve 5 cm for cutting wallpaper, bear in mind that a cutting out a roll of wallpaper, in case the rendering quality question.
3. Brush the wallpaper with glue
It is necessary to evenly brush the wallpaper glue of non-woven fabric on the wall with a thickness of 2mm, and never directly brush the glue on the opposite side of non-woven fabric, not to mention soaking in water. Non-woven fabric is different from other wallpaper, it should be thicker and thicker than other wallpaper glue, making it less mobile.
4. Wallpaper
The non-woven wallpaper is posted in the prearranged order.
5. Cut the construction wallpaper
Requirements on the laying construction, specific measure is on during the construction, on how many depends on pattern, about 3 cm long, plain non-woven fabric in positive and negative at the beginning of the construction method of construction, type of flowers after guarantee pattern alignment, the overlap with straightedge pressure, cutting, as far as possible to prevent cutting in Yang Angle place, avoid causing Yang wallpaper become warped edge Angle, guarantee the cutting blade when cutting, no raw edges, with attention to under the knife, to ensure that a cutting, act decisively, but not too far to the appearance of metope.
6. Post wallpaper cleaning
After construction, if there is dust on the outside, use a short brush or a duster to gently brush, not with a wet towel scrub resulting in pollution extension.
Note for non-woven wallpaper:
1. After the bottom coating is dry during construction, draw vertical lines as the standard to avoid incorrect position of wallpaper Posting.
2, after the wall paper on wall can't use hard scraper or nylon brush, should use soft brush to blow gently, by the non-woven fabric appearance, leveling to remove air bubbles, wrinkle, don't scrape the glue joint appearance, to avoid pollution if gets out glue immediately with a dry towel swabbed clean, as far as possible when construction keep hands clean.
3. During the construction, the construction should be checked at the same time. If there is any doubt, the construction should be stopped immediately.
|
